OGS Developer Training: small series starting this week

Announcements
1

Dear OGS community,

we’ll start a small OGS developer training series this week on Friday, 6 June 2025 10:00 – 10:30 in the usual C++ Club room (BBB). The series will have at least three weekly sessions (i.e., until 20 June 2025).

The topic of the series will be how degrees of freedom are handled in OGS: How the mapping from node and element ids to entries in the global matrices/vectors works and how to use it in the FEM assembly, pre- and postprocessing. So, it’s highly relevant for anybody implementing own processes, special source terms etc.

Everybody from the OGS user and developer community is welcome to join the trainings. If you want to participate and need the meeting link, please respond to this forum post and we’ll send you the link.

Best regards,
Christoph

5 Likes
2

Hi Christoph,

I would like to have the link to join the training sessions.

Thank you!
Regards,
María

3

Hello!

I would also like to attend the training sessions.

Thank you so much!

Regards,
Hans

4

Hello Sir,

I would like to join the training sessions. Kindly share the access link for the training sessions.

Also, I am really looking for similar kind of training on OGS-PHREEQC coupling.

Thank you so much sir.

Sincerely,
Md Mahmudul Hassan

5

Hello Christoph,

I didn’t check the discourse on time, and I am late. I would very much like the join the sessions.

Could you kindly share the link and schedule?

Best,
Pavan

6

Hi Christoph!

Thanks, I would like to participate. Is it still possible?
Best, Tuanny

7

Thank you for your interest in the developer training. I shared the link with you either via private message here on Discourse or via email. I hope I did not forget anybody.

See you tomorrow 10:00!

Best regards,
Christoph

8

Just FYI: The series still continues.
We just discussed using the d.o.f. table for BCs in OGS.
Next week (Friday, 27th June, 10:00, same place): d.o.f.s and Python BCs.